Enhanced TDS
Identification & Functionality
- Chemical Family
- Product Code
- MITM16706
- RTU Product Type
Features & Benefits
- Ready-to-Use Product Features
Applications & Uses
- Application Area
- Compatible Substrates & Surfaces
Properties
- Physical Form
- Dosage Information
- For most applications a dilution of 1:3 - 1:1 of the product in demineralized water is recommended. The amount of Protectosil® WS 340 PLUS to be applied and the concentration to be used are highly depending on the absorbancy of the substrate and the desired penetration depth.
- Very absorbent substrates may require up to 500 – 1000 g/m2 Protectosil® WS 340 PLUS (1:3 dilution in water).
- Gently stir the product before preparing the dilution. Protectosil® WS 340 PLUS should be applied by wet-on-wet flow coating to the saturation point. The solution should be applied in 2 - 3 coats without drying between the coats as the water repellent effect of Protectosil® WS 340 PLUS can develop within minutes. On vertical surfaces the solution should run down in the form of a clearly visible descending wet curtain. This is achieved by allowing the solution to flow against the surface of the building material without pressure.
Principal Information
- Group Principal Number
- S000006
- Principal
Storage & Handling
- Storage Information
- Substrates to be treated should be dry and clean. Acceptable surface cleaning methods include sandblasting and water blasting.
- Most liquid delivery devices (e.g. airless spraying equipment) are suitable. The material should not be atomized or applied with a brush.
- Due to its high water content Protectosil® WS 340 PLUS is frost-sensitive and should therefore not be used at temperatures below 0 °C. The ideal temperature range for the application is +5 °C to +40 °C.
- Protectosil® WS 340 PLUS should be stored at temperatures between +3°C and +40°C.
Other
- Appearance
- Milky-white liquid
- Appearance (SDS)
- Liquid
- Color (SDS)
- Milky white
- Explosive Nature (SDS)
- Not explosive
- Odor (SDS)
- Almost odorless slightly alcoholic
- Temperature Control
- Yes
- USA/DOT UN Number
- Not Applicable
- Material Composition
Value Units Test Method / Conditions Active Content 40.0 % % - Physical Properties
Value Units Test Method / Conditions Density 1.0 g/cm³ g/cm³ DIN 51757 Flash Point min. 95.0 °C °C DIN EN ISO 2719 Storage Temperature max. 104.0 °F °F - SDS Physical and Chemical Properties
Value Units Test Method / Conditions Autoignition Temperature (SDS) min. 100.0 °C °C Boiling Point (SDS) 97.5 °C °C DIN 51751 Density (SDS) 1.0 g/cm³ g/cm³ DIN 51757 Flash Point (SDS) min. 95.0 °C °C DIN EN ISO 2719 Viscosity (SDS) 7.1 Pa.s Pa.s DIN EN ISO 3219 at 20°C pH (SDS) 8.7 - DIN 19268 Concentration: 50% - Shelf Life & Stability
Value Units Test Method / Conditions Shelf Life 12.0 mo mo