BONDERITE® L-FG ADAG C

BONDERITE® L-FG ADAG C is suitable for a wide variety of applications such as; chain / thread lubricant, assembly lubricant, parting compound, general industrial lubricant, glass coating, impregnate coating, and electrical conductive coating.
Method of Use
Dilution BONDERITE® L-FG ADAG C is supplied as a concentrate and can be diluted with distilled, demineralized, or soft water prior to use. The dilution ratio varies according to the difficulty of the job and the degree of cooling, from 1:1 to 1:25 depending on the application. Important: Add water to concentrate, not the reverse. Stir the concentrate thoroughly then slowly add one part water while stirring until the mixture is homogenous. The remaining water may be added rapidly while stirring until the desired dilution and consistency are reached.

Application

Substrates must dry and free of dirt, dust, and grease. No further pretreatment is required, although chemical etching or sandblasting will improve adhesion and wear properties. For best results Bonderite L-FG ADAG C can be applied by conventional spray, brush, or dip methods. Spray application provides uniform coating thickness, complete die coverage, and lower friction values. In open or recirculating systems ammonia should be added periodically to maintain a pH of at least 10.

Curing

BONDERITE® L-FG ADAG C will air dry to touch in 10 – 15 minutes depending on room temperature and humidity. For optimum coating properties preheat the substrate to 200 - 350°F before coating or heat to air-dried coated part at 300°F for 5 minutes.

• Excellent dispersion stability resulting in little or no settling in the concentrate
• Ultra-fine graphite and proprietary binder chemistry produces faster substrate wetting
• Offers higher dilution ratios
• Excellent lubricity and release
• Good thermal stability
• Continual lubrication in extreme pressure areas