Enhanced TDS
Identification & Functionality
- Blend
- No
- CASE Ingredients Functions
- Chemical Family
- Function
- Binder
- Product Code
- MITM11159
- Single Ingredient
- Yes
- Technologies
- Product Families
Features & Benefits
- CASE Ingredients Features
- Performance Highlights
EBECRYL® 5848 is characterized by:
- Approximately 62% renewable content
- Moderate viscosity
- Good pigment wetting
- Good hydrophilic-lipophilic balance for lithography
UV/EB cured products based on EBECRYL® 5848 are characterized by the following performance properties:
- Enhanced adhesion on paper and metal
- Good surface appearance
- Improved substrate wetting
The actual properties of UV/EB cured products also depend on the selection of other formulation components such as reactive diluents, additives and photoinitiators.
Applications & Uses
- Application Method
- Coating End Applications
- Compatible Substrates & Surfaces
- Cure Method
- Ink & Toner End Applications
- Markets
- Applications
- Product Applications
Formulated UV/EB curable products containing EBECRYL® 5848 may be applied via direct or reverse roll, offset gravure, metering rod, slot die, knife over roll, air knife, curtain, immersion and spin coating methods, as well as flexographic, lithographic and screen printing.
EBECRYL® 5848 is recommended as a modifying resin for:
- Overprint varnishes for paper
- Lithographic ink vehicles
- Metal decorating and protective coatings
- Screen ink vehicles
- Pigmented coatings for wood
Properties
- Physical Form
Regulatory & Compliance
- Certifications & Compliance
- Contains any chemicals listed on Prop 65 (including impurities, residues, catalysts, monomers, and by-products and excluding heavy metals)?
Packaging & Availability
Principal Information
- Group Principal Number
- S000001
- Principal
Storage & Handling
- Storage Conditions
- Care should be taken not to expose the product to high temperature conditions, direct sunlight, ignition sources, oxidizing agents, alkalis or acids.
- This might cause uncontrollable polymerization of the product with the generation of heat.
- Storage and handling should be in stainless steel, amber glass, amber polyethylene or baked phenolic lined containers.
- Procedures that remove or displace oxygen from the material should be avoided.
- Do not store this material under an oxygen free atmosphere.
- Dry air is recommended to displace material removed from the container.
- Wash thoroughly after handling.
- Keep container tightly closed.
- Use with adequate ventilation.
Other
- Appearance
- Clear liquid
- Appearance (SDS)
- Clear liquid
- Color (SDS)
- Clear pale yellow
- Item Number
- Odor (SDS)
- Acrylate
- Other Hazards
- Polymerization may occur from excessive heat, contamination or exposure to direct sunlight .
- USA/DOT UN Number
- Not Applicable
- Optical Properties
Value Units Test Method / Conditions Color Scale max. 10.0 Gardner Gardner Gardner Color Scale - Chemical Properties
Value Units Test Method / Conditions Acid Value 9.6 mg KOH/g mg KOH/g Epoxy Group Content 0.14 % % - Physical Properties
Value Units Test Method / Conditions Density 1.03 g/mL g/mL At 25°C Viscosity 20000.0 mPa.s mPa.s At 25°C - SDS Physical and Chemical Properties
Value Units Test Method / Conditions Boiling Point (SDS) min. 100.0 °C °C Density (SDS) 1.05 g/cm³ g/cm³ Flash Point (SDS) min. 100.0 °C °C Cleveland Open Cup Vapor Pressure (SDS) max. 1.33 hPa hPa at 20°C Volatile Content (SDS) max. 0.5 %(W/W) %(W/W)